IMPROVING THE PERFORMANCE OF A PYRAMID-SHAPED SOLAR STILL | ||
| Misr Journal of Agricultural Engineering | ||
| Article 1, Volume 29, Issue 4, October 2012, Pages 1239-1254 PDF (501.15 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/mjae.2012.100472 | ||
| Author | ||
| M.A. Tawfik | ||
| Lecturer, Dept. of Agric. Eng., Fac. of Agric. Zagazig Univ., Egypt. | ||
| Abstract | ||
| The main goal of this study is to improve the performance of a pyramid-shaped solar still by studying some effective parameters on the still distillate yield and still instantaneous efficiency including solar radiation intensity, brine depth, water salinity, temperature difference between the glass cover and the brine. Thus a simple basin pyramid- shaped solar still with total area of 0. 64 m2 covered with four triangle clear sheets of glass with 3 mm in thickness without frame was fabricated and tested with auxiliary black materials in basin from 8 am to 6 pm under Zagazig city local climatic conditions (Latitude 30.5° N). The solar still performance was evaluated under three levels of brine depth (4 ,8 and 10 cm),two levels of water salinity (15000 and 35000 ppm) intended to simulate brackish water and seawater respectively using auxiliary black materials including black sponge cubes and black stones. The results showed that around the noon hour, using the black sponge cubes at water depth of 4 cm and water salinity of 15000 ppm gave the highest still instantaneous efficiency of 46.15 %, the highest temperature difference between the glass cover and the brine of 32.40 °C, the highest distillate and accumulated yield of 630.40 ml/h and 3620.45 ml respectively. Hence, it is recommended to operate the solar still at brine depth of 4 cm and water salinity of 15000 ppm using black sponge cubes to obtain the highest values of the distillate yield, accumulated yield and the instantaneous efficiency. | ||
| Keywords | ||
| solar still; brackish water; brine; auxiliary; distillate yield | ||
| References | ||
|
Aboul-Enein, S. , A.A. El-Sebaii and E. El-Bialy (1998). Investigation of a single -basin solar still with deep basins. Renewable Energy, 14: 299–305.
Bekheit, M., A.E. Kabeel, E.A. El-Negiry and A.M. Hamed (2001).Theoretical and experimental investigation of roof-type solar still augmented with corrugated wick of cloth layer. In: 12 International mechanical power engineering conference, Mansoura, Egypt; 73–85.
Bilal, A., S. Mousa , O. Omar and E. Yaser (1998). Experimental evaluation of a single-basin solar still using different absorbing materials. The Sixth Arab International Solar Energy conference.
Duffle, J.A., W.A. Beckman (1991). Solar engineering of thermal process. New York, USA: Wiley; 661 pp.
El-Sebaii, A.A. (2004).Effect of wind speed on active and passive solar stills, Energy Conversion Management, 45: 1187–1204.
Ernani, S. (1996). Solar still versus solar evaporator: A comparative study between their thermal behaviors. Solar Energy, 56(2):199-206.
Fath, H.E.S and H.M. Hosny (2002). Thermal performance of a single-sloped basin still with an inherent built-in additional condenser, Desalination, 142: 19–27.
Ghoneyem, A. and L. Arif (1997).Software to analyze solar stills and an experimental study on the effects of the cover, Desalination, 114: 37–44.
Kabeel, A.E. (2009). Performance of solar still with a concave wick evaporation surface, Energy 34: 1504–1509
Kalidasa, K.M., K. Chockalingama and K. Sritharb (2008). Progresses in improving the effectiveness of the single basin passive solar still. Desalination 220: 677–686.
Mosalam, A.S. (1997). Renewable energy in Egypt, The six Arab International Solar Energy Conference.
Rajesh ,T. and G.N. Tiwari (2005). Effect of water depth on internal heat and mass transfer for active solar distillation, Desalination; 173: 187–200.
Yazan,T. and M.T. Madhar (2012).Performance of pyramid-shaped solar still: Experimental study, Desalination,291:65-68. | ||
|
Statistics Article View: 180 PDF Download: 232 |
||
