ENGINEERING STUDIES ON ABSORBENT SURFACES TO IMPROVE THE PERFORMANCE OF SOLAR COLLECTORS | ||
| Misr Journal of Agricultural Engineering | ||
| Article 6, Volume 37, Issue 4, October 2020, Pages 393-406 PDF (719.53 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/mjae.2020.121552 | ||
| Authors | ||
| Ahmed T. Taha* 1; Manar M. Helal2 | ||
| 1Assoc. Prof., Ag. Eng. Dept., Fac. of Ag., Menoufia U., Egypt. | ||
| 2Res., Ag. Eng. Dept., Fac. of Ag., Menoufia U., Egypt. | ||
| Abstract | ||
| The aim of this work is to study the thermal performance of four configurations of absorber plates of solar air collectors under three levels of air mass flow rates (0.0199, 0.047 and 0.120kg/s) and fabricate an efficient and cheap solar air collector from recyclable aluminum cans. Solar air collectors were manufactured and tested under prevailing weather conditions of Shebin El-Kom city (30˚.54'N and 31 E), Egypt. Comparisons between the temperature difference of air across the collector and thermal efficiencies of the flat, aluminum cans, and v-corrugated plate solar air collectors were presented. The results revealed that the maximum thermal efficiency was obtained at mass flow rate of 0.047kg/s for an solar air collector with an absorber plate made of single layer of recyclable aluminum cans) type-I), whereas the lowest thermal efficiency was obtained for the solar air collector without cans (flat plate). The thermal efficiency of the solar air collectors depends principally on the solar radiation, surface geometry of the collectors and air mass flow rate. | ||
| Keywords | ||
| solar energy; solar air collector; aluminum cans; v-corrugated | ||
| References | ||
|
Akpinar. E. K.; and F. Kocyigit (2010) "Energy and exergy analysis of a new flat plate solar air heater having different obstacles on absorber plates". Applied Energy; 87: 3438–3450 Al varez, G.; J. Arce.; L. Lira.; and M.R. Heras (2004) "Thermal performance of an air solar collector with an absorber plate made of recyclable aluminum cans". Solar Energy; 77:107–13. Chukwujindu, N.S (2017) "A comprehensive review of empirical models for estimating global solar radiation in Africa". Renewable and Sustainable Energy Reviews; 78: 955–995.
El-Sebaii, A.A.; S. Aboul-Enein.; M.R.I. Ramadan.; S.M. Shalaby.; and B.M. Moharram (2011) "Thermal Performance investigation of double pass-finned plate solar air heater". Applied Energy; 88(5):1727–1739. Escobedo, Q.H.; F. Manzano-Agugliaro; and A. Zapata-Sierra (2010) "The wind power of Mexico". Renewable & Sustainable Energy Reviews; 14:2830 – 2840.
Jamil, B; and N. Akhtar (2017) "Comparative analysis of diffuse solar radiation models based on sky clearness index and sunshine period for humid-subtropical climatic region of India: A case study." Renewable and Sustainable Energy Reviews, 78: 329–355. Kabeel, A.E.; A.S.M. Khalil Shalaby; and M.E. Zayed (2016) "Investigation of thermal performances of flat, finned, and V-corrugated plate solar air heaters. " Solar Energy Engineering; 138: 051004-051007. Kalogirou, S. A (2004) "Solar thermal collectors and applications". Progress in Energy and Combustion Science; 30:231–295. Kurtbas, I.; and E. Turgut (2006) "Experimental investigation of solar air heater with free and fixed fins: efficiency and exergy loss". International Journal of Science & Technology, 1: 75-82. Omojaro, A.P.; and L.B.Y. Aldabbagh (2010) "Experimental performance of single and double pass solar air heater with fins and steel wire mesh as absorber". Applied Energy; 87:3759-3765. Saxena. A; Varun; and A.A. El-Sebaii (2015) "A thermodynamic review of solar air heaters". Renewable and Sustainable Energy Reviews, 43:863–890. Varun; R.P. Saini.; and S.K. Singal (2007) "A review on roughness geometry used in solar air heaters". Solar Energy; 81:1340–1350. | ||
|
Statistics Article View: 325 PDF Download: 657 |
||
