Effect of some Egyptian Cotton Varieties and Grades on Fibers and Yarn Mechanical Properties | ||
| Journal of the Advances in Agricultural Researches | ||
| Article 14, Volume 24, Issue 3 - Serial Number 91, September 2019, Pages 446-463 PDF (1 M) | ||
| Document Type: Research papers | ||
| DOI: 10.21608/jalexu.2019.163476 | ||
| Authors | ||
| Mohamed Abdelgawad Nassar1; Ibrahim Abass Elsaid1; Mohamed Abdelrahman Negm2; Mahmoud ElBagoury3; Rasha Amer3 | ||
| 1Fac. Agric., Saba Basha, Alex. Univ., Egypt. | ||
| 2Cotton Research Institute, Agric. Res. Center, Giza, Egypt | ||
| 3Cotton Arbitration and Testing General Organization | ||
| Abstract | ||
| This investigation was carried out at Plant Production Department, Faculty of Agriculture (Saba-Basha), Alexandria University, Egypt and at Cotton Research Institute, ARC, Giza, Egypt, to study the effect of cotton variety and lint grade on fiber and yarn mechanical properties during 2018 season. Two commercial Egyptian cotton varieties, G. barbadense namely: Giza 87 and Giza 96 as Extra-long staple (ELS) were used. Three lint cotton grades i.e., Good to Fully Good (G/FG), Good (G) and Fully Good Fair to Good (FGF/G) were used for each variety. Fibers were processed to combed yarns Ne 80. The H.V.I. classing 1000, Pressely, Stelometer and Cotton Classifying System (CCS) instruments were used to determine the physical and mechanical fiber properties.The grading system in Egypt depends upon the experience of the classer to determine grade and quality of the raw cotton according to the official grade standard of each cotton variety. The results indicated that classer's was highly significant correlated with all instrumentally measured traits (positively or negatively). The Extra-long cotton varieties had a highly significant effect for fiber properties The highest mean value of micronaire reading (3.51), maturity index (87%) , fiber length (UHML) (35.80 mm) , fiber strength (44.1 g/tex), fiber elongation(5.4 %), spinning constant index (222), reflectance degree (75.7) and trash count (112) were recorded for the Egyptian cotton variety Giza 96 .As for the lint cotton grades effect , it could be concluded that the highest lint cotton grade Good to Fully Good (G/FG) recorded the best of all fiber properties which as high value of micronaire reading , maturity index , fiber length(UHML), uniformity index, fiber strength, spinning constant index and less of short fiber index , yellowness degree and trash count vice versa. Cotton varieties (V) had highly significant differed for mechanical cotton properties measured by three instruments( HVI , Stelometer and Pressley) i.e. fiber strength and fiber elongation the highest mean values of the fiber strength ( 44.4 g / tex) , was attained by the cotton variety Giza 96. Whereas the lowest mean values (43.2 g/tex) and (4.8 %) of the fiber elongation. The conventional methods are biased toward the long, strong fibers in cotton, whereas the high speed instruments use less accurate, indirect methods to measure bundle mass and produce a force measurement that is confounded by differences in fiber crimp. When we compared single instrument testing (Pressley and Stelometer) with the HVI technology for evaluation of fiber properties is faster and coast less per measurement. The disadvantage of HVI for genetic modification for fiber properties may be reduced accuracy and ability to separate small differences. The HVI instrument had a highly significant effect on all studied fiber properties i.e. the micronaire reading , maturity index , fiber length , uniformity index , fiber strength , short fiber index, reflectance degree and yellowness degree .The highest mean value were (3.18), (85%) , (35.7mm), (86.4 %) , (47.6g/tex) , (5.7 %) , (76.0) and (9.4),respectively. of the maturity index, while the CCS instrument possessed the lowest mean of these traits. HVI measurements were calibrated across instruments using USDA cotton calibration standards making it possible to compare results from different instruments over a long period of time. In addition, cotton testing laboratories use cottons of known values throughout the day to check for a possible drift in measurements over time. | ||
| Keywords | ||
| Egyptian cotton; lint cotton grade; fiber properties; HVI; Pressley; Stelometer; CCS | ||
| References | ||
|
Beheary, M.G.I. (2005). Comparing HVI fiber properties with conventional methods Adv. Agric. Res. (Fac. Agric. Saba Basha) , 10 (l) : 122-132.
Constable, G. A. , D.J. Lewellyn , S.A. Walford and J.D. Clement (2015). Cotton breeding for fiber quality improvement. Industrial crops breeding for bioEnergy and bioproducts : 191-232.
El-Messiry, M. and Samar, A. M Abd-Ellatif (2013).Characterization of Egyptian cotton fibers. Indian J. Fiber and Textile Res., 38: 109-113.
Farzad, H. (2012). Investigation on the tensile properties of individual cotton (Gossypium hirsutum L.) fibers .M.Sc. , Thesis in crop science. Faculty of Texas, USA .
Farooq, J., A. Farooq , M. Rizwan , I. Valentin , M. A. Ali , K. Mahmood and A. Batool (2015). Cotton fibers: Attributes of specialized cells and factors affecting them. AES Bioflux, 7 (3) : 369-382.
Fouda, A. and A. M. Elhosseny (2018). Comparative study between the characteristics of the Egyptian and the sudanese cotton knitted fabrics. Textile Res. J. : 88-91.
Gomez, K. A. and A. A. Gomez (1984).Statistical Procedures in Agricultural Research, New York, Chichester , 2nd edition, paperback,2 : 680-700 .
Hequet, E. , B. Kelly and J. Dever (2015). Breeding for better fiber elongation: A key to improving yarn tensile properties Texas tech Uni. , AgriLife Res., Lubbock TX, U.S.A. Tex. J. Eng., 2:128-136.
Hunter, L. (1980). Textiles: Some technical. Information and data V: Cotton South African wool and textile research. Institute of the CSlR. Texas Tech. Univ., 13 (2):19-29.
Iqbal, S. F. (2018) . Influence of yarn structure produced in different spinning systems on the properties of yarn. Int. J. Applied Res., 4(4) : 172-176.
Jacquirine, M. (2016). The use of statistical techniques to study the relationship between cotton fibers and yarn properties – Acase study of Uganda rotor spun yarn . (BSc. Textile and Clothing Tech (Hons) , Kyambogo University, Kampala – Uganda.
Jane, D. (2012). Improving fiber elongation of U.S. germplasm 10-692TX. J. Tex. Sci. Eng ,8 : 330-335.
Koli, G. P. , D. V. Patil and A. B. Bagade (2014) .Comparative study for fiber quality parameters in cotton (Gossypium sp. L.) . Int. J. Current Microbiol and Applied Sci., 3(11) : 628-632.
Liu, Y., B. T. Campbell , C. Delhom and V. Martin (2016). Comparative relationship of fiber strength and yarn tenacity in four cotton cultivars . J. Mat. Sci. Res.; 5( 1):46-53
May, O.L. and G.M. Jividen (1999). Genetic modification of cotton fiber properties as measured by single- and High-Volume Instruments . Crop Sci., 39 (2) :328-333.
Negm, M. A. , Suzan H. Sanad and Zeinab E. Ghareeb (2016). Relationships between HVI and CCS and tensile yarn .World Cotton Res. Conf.-6. Brazil 02-06 May 2016.
Rogers, D. D. (2005). Engineering and ginning: The effect of harvesting procedures on fiber and yarn quality of ultra-narrow-row cotton. J. Cotton Sci., 9: 25-23.
Shouren, Y. and S. Gordon (2016). A study on cotton fiber elongation measurement. 3rd International cotton conference Bremen : 16-18.
Tesema G.B. and K. Hussein (2015). Comparison of different quantification methods to define fiber quality of Ethiopian, Indian & Egyptian cottons .Int. J. of Fiber and Textile Res. , 5 (2) : 9-15.
Tesema G.B. and K. Subramanian (2018). A study on the fiber parameters of cotton quality and process ability evaluation, J. Textiles and Engineer , 25(111): 182-188. | ||
|
Statistics Article View: 445 PDF Download: 621 |
||
