Studying the Effects of Accumulative Roll Bonding Cycles on the Mechanical Properties of AA1050 Aluminum Alloy | ||
| Journal of Petroleum and Mining Engineering | ||
| Article 7, Volume 23, Issue 1, June 2021, Pages 54-58 PDF (823.95 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/jpme.2021.69751.1080 | ||
| Authors | ||
| Eman Elshenawy1; Abdelrahman Alanany2; ahmed EL-Nikhaily2; Ahmed Essa* 2 | ||
| 1Central Metallurgical Research and Development Institute (CMRDI), Metals Technology Division, P.O. 87 Helwan | ||
| 2Mechanical Department, Faculty of Technology and Education, Suez University, Suez, Egypt | ||
| Abstract | ||
| Accumulative Roll Bonding (ARB) is a prospective severe plastic deformation (SPD) process that can continuously produce bulk material and has good commercialization potential. This paper aims to study the effect of different ARB cycles in details on tensile strength, elongation, and strain-hardening coefficient. Aluminum sheets AA1050 were heated at 300⁰C, then rolled for a single pass with 67% reduction in thickness and air cooled. The produced sheet was cut and accumulative roll bonded (50% reduction) after reheating at 280⁰C with different ARB cycle regimes. The tensile testing was carried out at room temperature after different cycles of ARB. Ultimate tensile strength, elongation, and strain-hardening coefficient were determined. The results indicated that UTS after ARB is significantly improved by accumulative roll bonding achieving 121% of AA1050. This improvement is attributed to the reduction of grain size and increasing the grain boundaries. However, the total elongation percentage were reduced, at which the elongation reduced by a factor 95% of AA1050." | ||
| Keywords | ||
| Pure Aluminum; Preheated; Accumulative Roll bonding; Ultimate Tensile Strength (UTS); Strain-Hardening Coefficient | ||
|
Statistics Article View: 453 PDF Download: 488 |
||
