The influence of Alkaline Granite addition on Ceramic Body Sintering | ||
| Egyptian Journal of Chemistry | ||
| Volume 66, Issue 9, September 2023, Pages 65-76 PDF (921.07 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/ejchem.2022.162951.6982 | ||
| Authors | ||
| Mohamed Elmaghraby1; Nahla Abd El Ghaffar* 2; Ali.I.M. Ismail2 | ||
| 1Ceramics, Refractories and Building Materials Department, National Research Centre, Dokki, Cairo, Egypt | ||
| 2Geological Sciences Department, National Research Centre, Dokki, Cairo, Egypt | ||
| Abstract | ||
| The area under investigation is located in southern Sinai where a wide distribution of alkaline granite is occurred. These granites are promising for the production of feldspars specially the potassic varieties. Alkaline- granite was added on the ceramic bodies sintering at different temperatures from 1140OC to 1200OC. Four batches (50/50, 60/40, 70/30, 75/25) of granite to clay ratio were designed to investigate the effect of the granite/clay ratio on the phase composition and densification parameters. Mineralogical and chemical composition of the starting raw materials was evaluated using XRD and XRF, phase composition, densification parameters, and microstructure of the fired batches were studied. The densification parameters decrease as increasing granite ratio and decreasing of clay. For the effect of the temperature, the bulk density, porosity, and water absorption decrease with increasing of the firing temperature, in batch no 1 and 2. Batch no 3, bulk density and linear shrinkage decrease, while apparent porosity and water absorption increase. Batch no 4. Bulk density and linear shrinkage decrease, apparent porosity and water absorption slightly increase till 1180 oC and decrease at 1200 oC. X ray diffraction (XRD) and scanning electron microscope (SEM) with Energy-dispersive X-ray spectroscopy (EDX) confirm that quartz and mullite are only two phases detected. Feldspar was totally replaced by alkaline granite in the formation of vitrified ceramic tile masses. Alkaline granite is better sintering behavior it reduces the vitrification temperature and decreases the water absorption from 1140 to 1200oC. In the production of ceramic tiles, the whitener of the fired product is not a required parameter; the substitution of feldspar for alkaline granite can be more beneficial due to the relatively higher cost of feldspars. | ||
| Keywords | ||
| Granite; Sintering; Clay; Ceramic Densification Parameters; Firing Temperature | ||
|
Statistics Article View: 210 PDF Download: 162 |
||
