Influence of Preheating on the Grindability of Mono/Poli Mineral Ores | ||
| JES. Journal of Engineering Sciences | ||
| Article 5, Volume 51, Issue 3, May and June 2023, Pages 15-26 PDF (543.08 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.21608/jesaun.2023.181570.1189 | ||
| Author | ||
| sherein A rizk* | ||
| Faculty of Engineering, Beni-Suef University, Beni-Suef, Egypt. | ||
| Abstract | ||
| In grinding practice, heterogeneous poli-mineral systems are more common than homogeneous mono-mineral system. The heterogeneity of raw materials in mineral beneficiation grinding circuit results by virtue of the varying properties of mineral constituents in an ore. Therefore, the main objective of this investigation is to study the effect of preheating on the grindability of quartz as a mono-mineral ore, and nepheline syenite as a poli-mineral one. 2n Factorial method was applied to arrange the studied parameters affecting the preheating of each of the two studied ores according to the importance of their relative effect on its grindability. The results revailed that incremented percentage of -200 µm in the preheated ground poli-mineral ore was less than that of mono-mineral one by about 32.9%. This behavior was interpreted by containing nepheline syenite on more than one mineral, consequently, phase change anisotropic thermal expansion or contraction of the grain boundries have a markedly effect on the grindability of preheated rocks, especially those contain more than one mineral. | ||
| Keywords | ||
| Comminution of preheated ores; Preheating as an aid to comminution; Grinding of mono/poli mineral ores | ||
| References | ||
|
[1] Kawatra, S.K., “Temperature effect on grinding circuit performance”, Miner. Metall. Process, Vol.6, No.2, pp.85-87, 1989.
[2] Kawatra, S.K., “Effect of temperature on the energy efficiency of an industrial circuit processing iron ore”, Miner. Metall. Process, Vol.8, No.1, pp.32-37, 1991.
[3] Lytle, J., Cohi, N., and Prisbrey, K., “Influence of preheating on grindability of coal”, Int. J. of Mineral Processing, Vol.36, pp.107-112, 1992.
[4] Ahmed, A.A., and Rizk, A.M., “Influence of thermal treatment on the grindability of feldspar”, 8th Inter. Conf. on Mining, Petroleum and Metall. Engng. (MPM8) Suez Canal Univ., Egypt, 17-19 March, pp.305-315, 2003.
[5] Ahmed, A.A., Ahmed, M.M., and Rizk, A.M.E., “Preheating as an aid to comminution process”, Journal of Engng. Sciences (JES), Faculty of Engng. Assiut University, Vol. 31, No.4, pp.985-994, 2003.
[6] Walkiewicz, J.W., Indroth, D.P., and Clark, A.E., “Iron ore grindability improved by heating”, E& MJ, pp.16B-16C, 1996.
[7] Ersayin, S., Ergun, L., and Benzer, H., “The effects of heat treatment on grinding and liberation of chromite ore”, Progress in Mineral Processing Technology, Demirel & Ersayin (Eds), pp.33-37, 1994.
[8] Fitzgibbon, K.E., and Veasey, T.J., “Thermally assisted Liberation- a review”, Minerals Engng., Vol.3, No. 1/2, pp.181-185, 1990.
[9] Sener, S. and Ozbayoglu, G., “Effect of heat treatment on grindability of ulexite”, Innovations in Mineral and Coal Processing, Atak, Onal and Celik (Eds), Balkema, Rotterdam, pp. 29-31, 1998.
[10] Pocock, S., Veasey, T.J., Tavares, L.M., and king, R.P., “The effect of heating and quenching on grinding characteristics of quartzite”, Powder Techn., Vol.95 pp.137-142, 1998.
[11] Wonnacott, G., and Wills, B.A., “Optimization of thermally assisted liberation of a tin ore with the aid of computer simulation”, Minerals Engng., Vol.3, No.1/2, pp.187-198,1990.
[12] Geller, L.B., and Tervo, R.O., “Grinding of preheated rocks”, Trans. IMM, Sec.C., Vol.25, pp.25-33, 1975.
[13] Black burn, S, and Veasey. T. J., “Effect of heat treatment in air at 820-960° c on magnetic properties of wolframite”, Trans. IMM, Vol.93, pp.85-88, 1984.
[14] Hariharan and Venkatachalam, S., “Influence of thermal treatment upon grindability of quartz”, Mining Magazine, pp.105-108, 1977.
[15] Veasey, T.J., and Wills, B.A., “A review of methods improving mineral liberation”, Minerals Engng., Vol.4, No.7-11, pp.747-752, 1991.
[16] Wang, E., Shi, F., and Manlapig, E., “Factors affecting electrical comminution performance”, Minerals Engng., Vol.34, pp.48-54, 2012.
[17] Shadi, A., Ahmadihossini, A., Rabiei, M., Samea, P., Hassani, F., Sasmito, p., and Ali, S., “Numerical and experimental analysis of fully coupled electromagnetic and thermal phenomena in microwave heating of rocks”, Minerals Engng., Vol.178, 107406, 2022.
[18] Hao, J., Qiao, L., and Li, Q., “Study on cross-scale pores fractal characteristics of granite after high temperature and rock failure precursor under uniaxial compression”, Powder Technology, 401, 117330, 2022.
[19] Parker, T., Shi, F., Evans, C., and Powell, M., “The effects of electrical comminution on the mineral liberation and surface chemistry of a porphyry copper ore”, Minerals Engng., 82, pp.101-106, 2015.
[20] Hartlieb, P., Toifl, M., Kuchar, F., Meisels, R., and Antretter, T., “Thermo-physical properties of selected hard rocks and their relation to microwave-assisted comminution “, Minerals Engng., 91, 34-41, 2016.
[21] Hassani, F., Shadi, A., Rafezi, H., Sasmito, A.P., and Ghoreishi-Madiseh, A.G., “Energy analysis of the effectiveness of microwave-assisted fragmentation”, Minerals Engng., 159, 106642, 2020.
[22] Che, L., Gu, X., and Li, H., “Numerical analysis and experimental research on hard rock fragmentation by high voltage pulse discharge”, Minerals Engng., 168, 106942, 2021.
[23] Parapari, P.S., Parian, M., Palsson, B.I., and Rosenkranz, J., “Qualitative analysis of ore texture breakage characteristics affected by loading mechanism: Multivariate data analysis of particle texture parameters”, Minerals Engng., 181 107531, 2022.
[24] Ji, B., and Zhang.W., “The effect of mechanical grinding and thermal treatment on the recovery of rare earth elements (REEs) from kaolinite”, Powder Technology 394, 621-631, 2021.
[25] Abouzeid, A.Z.M., “Market specification of raw materials for ceramics industry”, 7th Inter. Conf. on Mining, Petroleum and Metall. Engng. (MPM), Assiut Univ., Egypt, pp.101-108, 2001.
[26] Ezz-Eldin, M., Abouzeid, A.M., El madawy, kh. Khaled, A.M., and El Sherif, R.E., “Mineral industry in Egypt-Part Π Non-Metallic Commodities-Silica Ores”, J. of Mining World Express (MWE), Vol.5, 2016.
[27] Pan, X., Li, Y., Guo, P., Zhao, X., and Cai.Y.“Resource, characteristic, purification and application of quartz: a review”, Minerals Engng., 183, 107600, 2022.
[28] Ipek, H., Ucbas, Y., and Hosten, C., “Ternary-mixture grinding of ceramic raw materials”, Minerals Engng., 18, pp. 45-49, 2005.
[29] Mehrim, M.R., “Energetic of comminution”, M. Sc thesis, Mining and Metall.Engng. Dept., Faculty of Engng, Assiut University, 1970.
[30] Miller, R.E., “Experimental design”, Chem.Engng., Vol.23, June, pp.113-117, 1986.
[31] Rizk, S.A., “A study on the effect of physical and mechanical properties of rocks on their grindability”, Journal of Engng. Sciences (JES), Faculty of Engng., Assiut University, Vol.46 No.5, pp.574-586, 2018.
[32] Davis, O.L., and Goldsmith, P.L. (Editors), “Statistical methods in research and production”, Edinburgh, Fourth Edition, 1972.
[33] Botteril, J.S., “An introduction to simple statistical experimental design”, British Chem.Engng. Vol.9, No.3, 1964.
[34] Sikong, L., Hashimoto, H., and Yashima, S., “Breakage behavior of fine particles of brittle mineral and coal”, Powder Tec., Vol.61, pp.51-57, 1990.
[35] Martello, E.D., Bernardis, S., Larsen, R.B., Tranil, G., Sabatino, M.D., and Arnberg, L., “Electrical fragmentation as a novel refining route for hydrothermal quartz for SoG-Si production”, Minerals Engng., Vol.224, pp.209-216, 2012. | ||
|
Statistics Article View: 178 PDF Download: 522 |
||
