DC-DC Boost Converter for Enhancing the Generated Output Voltage from Microbial Fuel Cell | ||
| Journal of Scientific Research in Science | ||
| Articles in Press, Corrected Proof, Available Online from 20 December 2023 | ||
| Document Type: Original Article | ||
| DOI: 10.21608/jsrs.2023.170623.1092 | ||
| Authors | ||
| Hager Meatimed* 1; aya sayed rady2; Sanaa Kamh3; Soha Mohamed Abd El-Azeem4 | ||
| 1Physics Dept., Faculty of Engineering and Technology, Modern Academy | ||
| 2Biophysics research group, Physics Department, Faculty of Women for Arts; Science and Education, Ain Shams University, Cairo, Egypt. | ||
| 3Electronic Research Lab., Physics Department, Faculty of Women for Arts; Science, and Education, Ain Shams University, Cairo, Egypt | ||
| 4Electronic Research Lab., Physics department, Faculty of Women for Arts, Science, Education, Ain Shams University, Cairo, Egypt | ||
| Abstract | ||
| Microbial Fuel Cell (MFC) represents a promising approach for generating power inexpensively. Moreover, it is considered as an alternative green energy source. It could generate electrical energy by utilizing a wide range of organic substrates, as well as complex organic matter present in various environmental wastes depending on the bio-catalysis of microorganisms. However, the utilization of MFC in electronic applications is limited, due to its low output power density and output voltage. The present work aims to enhance the generated output voltage of a single MFC by applying DC-DC boost converter circuit. Before applying this circuit, a similar stacked series 6- MFCs are constructed for increasing its generated output voltage (on average 1.04V), where their produced output voltage reached about 6.24 V. In most electronic applications, the required voltage and current exceed these values. Hence, as a solution, a DC-DC boost converter circuit is recommended with an input voltage of 6 V based on the voltage harvested from the cascaded series 6-MFCs using 6V/2A lead acid battery. In this work, the designed converter was operated in the discontinuous conduction mode (DCM) giving a variety of output voltage ranging from 15.8 V at load resistance (RL) of 220 Ω up to 21.2 V at RL of 620 Ω. | ||
| Keywords | ||
| Microbial fuel cell; Boost Converter; Energy harvesting; Output voltage | ||
|
Statistics Article View: 90 |
||
