Hasan, S., El-Refaie, E., Hamada, A., Alaboudy, A. (2016). An AC Current Limiting and Interrupting Device for Low Voltage Systems. test, 20(2), 110-117. doi: 10.21608/pserj.2016.33666
Saady Hasan; El-Sayed El-Refaie; Abdallah Hamada; Ali Kasem Alaboudy. "An AC Current Limiting and Interrupting Device for Low Voltage Systems". test, 20, 2, 2016, 110-117. doi: 10.21608/pserj.2016.33666
Hasan, S., El-Refaie, E., Hamada, A., Alaboudy, A. (2016). 'An AC Current Limiting and Interrupting Device for Low Voltage Systems', test, 20(2), pp. 110-117. doi: 10.21608/pserj.2016.33666
Hasan, S., El-Refaie, E., Hamada, A., Alaboudy, A. An AC Current Limiting and Interrupting Device for Low Voltage Systems. test, 2016; 20(2): 110-117. doi: 10.21608/pserj.2016.33666

An AC Current Limiting and Interrupting Device for Low Voltage Systems

Port-Said Engineering Research Journal
Article 11, Volume 20, Issue 2, September 2016, Pages 110-117    PDF (956.93 K)
Document Type: Original Article
DOI: 10.21608/pserj.2016.33666
Authors
Saady Hasan1; El-Sayed El-Refaie1; Abdallah Hamada2; Ali Kasem Alaboudy2
1Electrical Department, Faculty of Engineering, Helwan University, Helwan, Egypt
2Electrical Department, Faculty of Industrial Education, Suez University, Suez, Egypt.
Abstract
This paper describes the development of the hybrid fault current limiter and interrupting device (HCLID) which can be used successfully as a fast short-circuit protection means for low voltage AC industrial installations. The main components of the HCLID are a solid state commutation circuit that can supply a counter current injection from a stand-by pre-charged capacitor, saturable core reactor as the limiting impedance and fast mechanical contact switch all connected in parallel. Through this study, we can present a significantly improved and simplified approach that replaces the half-controllable silicon-controlled rectifier (SCR) in the commutation circuit with self-turn-off device such as integrated gate-commutated thyristor (IGCT). The use of high-performance semiconductors (IGCTs) as the commutating affords reduced recovery voltage, reduced losses, improved reliability and dynamic performance, and fast switching time (in μs). The new approach involves a fault detection using rate of current rise rather than the current magnitude and a time delay operating characteristic based on Piecewise Linear Electrical Circuit Simulation (PLECS) program. The control method is very simple. Simulations carried out during the research. Simulation results proved the practicability and validity of the new HCLID.
Keywords
Hybrid Current Limiting Interrupting Device; Self-Turnoff Device; Fast Mechanical Contact Switch; control strategy; PLECS package application
Statistics
Article View: 245
PDF Download: 278