MARGINAL FIT ASSESSMENT OF CAD/CAM ZIRCONIA CROWNS FABRICATED BY DIGITAL SCANNING OF DIES AND SILICONE IMPRESSION (IN VITRO STUDY) | ||
| Alexandria Dental Journal | ||
| Article 2, Volume 49, Issue 3, December 2024, Pages 106-112 PDF (373.6 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/adjalexu.2023.206918.1370 | ||
| Authors | ||
| Ahmed Mohamed Ramadan* 1; Yousria Attia Shalaby2; Naguib Ahmad El fawal3 | ||
| 1fixed prosthodontics , faculty of dentistry , pharos university. | ||
| 2Conservative Dentistry Department, Faculty of Dentistry, Alexandria University | ||
| 3Conservative Dentistry Department, Faculty of Dentistry | ||
| Abstract | ||
| Introduction: The precision of impressions has a significant impact on the marginal adaptation of fixed restorations. Fit is the most significant factor influencing the restoration's durability, retention, and periodontal health. Aim of study: to compare the marginal fit of CAD/CAM zirconia crowns manufactured using two distinct digital impression techniques. Materials and methods: A typodont tooth in the upper premolar region was prepared to receive a complete ceramic crown. A direct scan of the prepared tooth was used to create twenty 3D-printed resin impressions. The master dies were divided into two groups at random (n = 10 per group). Group I: scanning the dies digitally. Group II: digital digitization of the scannable impressions of scannable silicone. Using cone beam CT, the marginal gap and marginal discrepancy were evaluated. Results: Group I had a marginal gap of (119.5 ± 27.0) µm, which was substantially smaller than Group II's (144.8 ± 25.23) µm, and a marginal discrepancy of (107.5 ± 36.36) µm, which was smaller than Group II's (154.3 ± 49.53) µm. Conclusion: Although direct digital scanning was superior to indirect digital scanning in terms of marginal fit, all tested techniques yielded clinically acceptable fit values. Keywords: Marginal fit, CAD/CAM, digital impression. Running title: Marginal fit of zirconia crowns fabricated by direct and indirect digital scanning. | ||
| Keywords | ||
| Marginal fit; CAD/CAM; digital impression | ||
|
Statistics Article View: 132 PDF Download: 257 |
||
