Reduced Graphene Oxide / Zinc Oxide / Silver Nanocomposites Trigger Visible Light Activity for Efficient Photocatalytic Degradation of Xylenol Orange as a Persistent Pollutant Model | ||
| Egyptian Journal of Chemistry | ||
| Articles in Press, Accepted Manuscript, Available Online from 05 February 2025 | ||
| Document Type: Original Article | ||
| DOI: 10.21608/ejchem.2025.329729.10660 | ||
| Authors | ||
| Samar El-Shahat1; Ahmed Nabile Emam* 2; Maher I El-Dessouky3; Gehad Genidy Mohamed4 | ||
| 1Postgraduate Student, Chemistry Department, Faculty of Science - Cairo University | ||
| 2Refractories, Ceramics and Building Materials Department, Advanced Material Technology & Mineral Resources Research Institute, National Research Centre (NRC), El Bohouth St., Dokki, 12622 Cairo, Egypt. | ||
| 3Chemistry Department, Faculty of Science, Cairo University, 12613, Giza, Egypt | ||
| 4Chemistry Department, Faculty of Science, Cairo University, 12613, Giza, Egypt Nanoscience Department, Institute of Basic and Applied Sciences, Egypt-Japan University of Science and Technology, New Borg El Arab, 21934, Alexandria, Egypt | ||
| Abstract | ||
| The use of heterojunctions in photocatalysis captures solar energy better, improving charge separation and transfer, thus enhancing photocatalytic activity and stability. This approach has the potential to alleviate energy and environmental challenges. In this study, metal oxide (i.e., ZnO NPs) and metal/metal oxide junctions (i.e., ZnO/Ag NPs) nanostructures were investigated. Two nanohybrids, labeled as ZnO-rGO and ZnO/Ag-rGO, were chemically prepared through a low-temperature wet chemical route. The physicochemical properties were altered by the presence of graphene in the prepared metal oxide and metal/metal oxide nanohybrids, as elaborated by the Brunauer–Emmett–Teller (BET) surface area, transmission electron microscope (TEM), X-ray diffraction (XRD), UV–visible absorption spectra, dynamic light scattering (DLS), and zeta potential techniques. In addition, photocatalytic performance was investigated through several parameters such as the effect of contact time, pH, catalyst, and dye concentrations, respectively. The results obtained indicated a remarkable increase in photodegradation efficiency upon the addition of graphene to metal and metal/metal oxide heterojunction nanostructures, with an efficiency ranging from 88 to 90% within 180 minutes compared to their pristine individual components. | ||
| Keywords | ||
| Zinc oxide; Plasmonic/Metal oxides nanohybrids; reduced graphene oxide; photodegradation; removal efficiency; Xylenol orange | ||
|
Statistics Article View: 118 |
||
