MANUFACTURING AND EVALUATION OF PROTOTYPE FOR MELON SEED EXTRACTION | ||
| Misr Journal of Agricultural Engineering | ||
| Article 9, Volume 34, Issue 2, April 2017, Pages 699-724 PDF (1.15 M) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/mjae.2017.96458 | ||
| Authors | ||
| M. Neamtallah1; R. Kholief2; R. A. Hegazy3; I. Abdelmotaleb4 | ||
| 1Assistant Researcher, Agric. Eng. Res. Inst., Dokki, Giza, Egypt. | ||
| 2Head Research, Agric. Eng. Res. Inst., Dokki, Giza, Egypt. | ||
| 3Associate Professor, Agric. Eng. Dept. Faculty of Agric. Kafrelsheikh University, Egypt. | ||
| 4Professor, Agric. Eng., Dept., Faculty of Agric., Kafrelsheikh University, Egypt. | ||
| Abstract | ||
| Manual extraction process of melon seed is the most-used method in Egypt and requires large number of labors. In addition to high cost associated with the manual extraction. So, this research therefore developed locally manufactured prototype to mechanically extract seeds from melon with lower cost and higher productivity. The manufactured prototype consists of frame, feeding hopper, crushing and extracting unit, peels outlet, conveying auger of seeds, cleaning brushes and seeds outlet. Proposed prototype was tested and evaluated at Eletad village and Rice Mechanization Center (RMC), Agricultural Mechanization Research Institute, Ministry of Agriculture (Meet El Dyba, Kafr El-Sheikh governorate) during the year of 2015. The prototype evaluation done based on cleaning efficiency, extraction efficiency, machine productivity, power consumed, seed damaged and operational cost. Prototype evaluation was done at four different feeding rates (20, 30, 40 and 50 kg/min), five drum speeds (3.25, 5.47, 6.98, 8.52 and 10.64 m/s) and four time spans (0, 3, 6 and 9 days). The results showed that the increase in crushing drum speed, melon seed time span and decreasing feed rate tend to decrease the cleaning efficiency, where the highest value of cleaning efficiency was 88.83 % at crushing drum speed of 10.64 m/s, feed rate of 20 kg/min and melon seed time span 9 days after harvesting. Also, the decrease of crushing drum speed, melon seed feed rate and increasing melon seed time span tend to increasing extraction efficiency, where the maximum value of extraction efficiency was 98.85 % at crushing drum speed of 3.25 m/s, feed rate of 20 kg/min and melon seed time span 9 day. Machine productivity increased by increasing feed rate, melon seed time span and decreasing crushing drum speed, where maximum value of machine productivity was 152.14 kg/h at crushing drum speed of 3.25 m/s, feed rate of 50 kg/min and melon seed time span 9 day. Power consumption increased by increasing crushing drum speed, melon seed feed rate and melon seed time span, where the minimum value of power consumption was to 2.61 kW at crushing drum speed of 3.25 m/s, feed rate of 50 kg/min and melon seed time span 9 day. Total costs increased by increasing crushing drum speed and decreasing both melon feed rate and melon seed time span, where the minimum value of total cost was 0.273 LE/kg at crushing drum speed of 3.25 m/s, melon seed feed rate of 50 kg/min and melon seed time span 9 day. | ||
| References | ||
|
Abd El-Mageed, H.N. and H.E. Abd All (1994). A simple machine for grading fresh tomatoes. J. Agric. Sci., Mansoura Univ., 19(9): 3033-3047.
Abdrabo, A.F.A (2014).Manufactured prototype to separate the seeds of melon pulp Egypt. J. Agric. Res., 92 (1)237:255.
Abou-Elmagd, A.E., H.N Abd El-Mageed, M.A. Baiomey and I.F. Sayed-Ahmed (2006).Proper design and evaluation of equipment for extracting melon seed, J. Agric Sci. Mansoura Univ., 31(7): 53-68.
Amir, I.F.S (2004). Construction and performance of machine for separating watermelon seed. Ph.D. Thesis., Fac. Of Agric Mansoura, Univ., Egypt. Unpublished.
Awady, M.N. and A.S. (1994). Separation of peanut by airstream Misr J. Ag. Eng.,11(1): 137-147.
Barger, E.L., J.B.L. Edohi, W.M. Carletor and E.G. Mchibben (1963).Tractor and their power units. 2nd Ed., Wiley. Sons Inc, New Yourk, USA.
Desta, K.D. and T.W. Mishra (1990). Development and performance evaluation of Sorghum thresher. AMA, 21(3): 33-37.
Dutta, S.K.; V.K. Nema and R.K. Bhardwaj (1988). Physical properties of grain. J. Agric. Eng. Res., 39: 259-268.
Egbe, D.E., E.G. Ebot, T.S. Mayah, P.A. Egbe and J.P. Abraham (2015). Performance Evaluation and Improvement Melon Seed Shelling Machine. World Journal of Agricultural Sciences &Engineering 1(1):1 –10.
Eliwa, A.A and A. Elfatih (2012). Developing a local extraction melon seed machine. Journal of Applied Sciences Research, 8(1): 474-482.
Ministry of Agriculture (2012). Agricultural statistics, Economic Issues sector, Cairo, Egypt: 78-115.
Oloko, S.A. and L.A.S. Agbetoye (2006). Development and Performance Evaluation of a Melon Depodding Machine. Agricultural Engineering International. The CIGR Ejournal. Manuscript. PMD 6018 Vol. vii.
Rangasamy, K., M. Balasubramanian and K.R. Swaminathan (1993). Evaluation of power weeder performance. AMA, 24(4): 16-18.
Shreen, F.A.M. (2014). Development and evaluation of a local industrial machine for watermelon on seeds extraction. J. Soil Sci. and Agric. Eng., Mansoura Univ. 5(10): 1405-1426.
Sobowale S.S., J.A. Adebiyi and O.A Adebo (2015). Design, Construction and Performance Evaluation of a Melon Seeds Sheller. J. Food Process Technol. 6: 463.
Tayel, S.A., A.A. EL-Nakib, M.F. Akhairy and D.M. Desiuky (2010).Factors affecting Cucurbita-pepo crop seed losses and damage by using a seed extracting machine prototype. Misr j. Ag., 27(3): 824-838.
Yehia, I., M.H. Kabeel and M.M. Abdel Galeel (2009). Physical an mechanical properties of Ponkan mandarin applied to grading machine, Misr J. Ag. Eng. 26(2): 1036-1053. | ||
|
Statistics Article View: 193 PDF Download: 308 |
||
