SOME ENGINEERING FACTORS AFFECTING FISH BY- PRODUCTS RECYCLING | ||
| Misr Journal of Agricultural Engineering | ||
| Article 13, Volume 33, Issue 1, January 2016, Pages 213-228 PDF (757.16 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/mjae.2016.98182 | ||
| Authors | ||
| I. S. EL- Soaly1; Alaa eldin A. El-Mesery1; M. E. Shetawy2; G. G. Emam3 | ||
| 1Prof., Agr. Eng., Fac. of Agr. Eng., Al-Azhar Univ., Cairo, Egypt. | ||
| 2Assis . Prof., Agr. Eng., Fac. of Agr. Eng., Al-Azhar Univ., Cairo, Egypt. | ||
| 3Demonstrator , Fac. of Agr. Eng. Al-Azhar Univ.,cairo, Egypt. | ||
| Abstract | ||
| The main objective of the present work is to Study the properties of the fish by-products which result from the fish industry (Fillet tilapia) and the proportion of edible parts to non-edible parts tilapia fish from natural. Some physical properties of tilapia fish and its by-products .The drying behavior of Nile fish by- products was investigated in a mechanical dryer and the mathematical modeling by using thin layer drying model (Lewis's models) was used. The impact of the drying air temperature (60, 70 and 80 0C) ,hot air velocity ( 1.0 ,1.5 and 2 ms-1) and The thickness layer(5,7 and 9 mm ) on the fish moisture losses against drying time has been studied. Drying rate, moisture ratio, cost estimation and Chemical assays of the drying process were also considered. The obtained data showed that,average mass fish, skin, trimming, viscera, Head, backbone and meat 373.815, 12.002, 16.325, 34.631, 67.657, 54.88, 187.136 g respectively. The shortest drying time of the fish was recorded at 150 min with 80 0C drying air temperature, thickness layer 5mm and 2 ms-1 air velocity. While, the longest drying time was recorded at 510 min with 60 0C, thickness layer 9 mm and 1 ms-1 treatments .Moisture content decreased from an initial level of about 106.5% (d.b.) to range between 4.4and 2.2% (d.b.) at the end drying process depending on the drying conditions. Moreover, drying rate was increased with the increase of drying air temperature, air velocity and reducing the thickness of the layer. Between tested model, the modified simple exponential model was found to be the most suitable for describing the drying behavior of the fish by-products. The effects of drying air temperature and velocity on the drying constant and coefficient were also shown. On the other hands, the calculated operation cost of the dryer approaches about 2.92 LE/kg of dried whole fish by-product. The protein content in the final product 45%. | ||
| References | ||
|
Ali, A. H., (2000) Advanced Studies on vital remnants of some aquaculture., Ph.D., Department of Chemistry, College of Agriculture, University of Minya.12-18.
AOAC,(2005). Official Methods of Analysis. AOAC., International , Maryland, USA.
Awady,M.N.;I.Yehia.,M.T.Ebaid and E.M.Arif(2003).Development and theory of rice cleaner for reduced impurities and losses . Misr J.Ag.Eng.,20(4):53-68.
Duan, Z. H.; L. N. Jiang.; J. L.Wang.; X. Y. Yu and T. Wang ,(2011). Drying and quality characteristics of tilapia fish fillets dried with hot air-microwave heating. Food and Bioprod. processing. 89:472-476.
Dumay J., (2006). Extraction de lipides en voie aqueuse par bioréacteur enzymatique combiné à l'ultrafiltration : application à la valorisation de co-produits de poisson (Sardina pilchardus ). Ph.D. Thesis.133-143
El Said, E.A.; F. Zabady and S. Dosoky, (2011). Drying of fish farm residuals. Misr J. Ag. Eng., 28 (1): 637 – 646.
FAO.,(2010)The State of World Fisheries and Aquaculture 2010, The World Review of Fisheries and Aquaculture, (FAO,( 2010 )
GAFRD.,(2013) General Authority for Fish Resources Development Egypt.
Ibrahim, M. H.;A.A. Camel;F.O. Farag and F.I. Mohamed, (2001) fish technology. Faculty of Agriculture., Ain Shams University. Open Learning Centre .book .,355:365.
Keshava.P. N.; A. Manjunatha Reddy.; N.S. Sudhakara and R.M. Prabhu,(2013). Physical and Chemical Properties of Filleting Waste from Grouper and Goat Fish. International Journal of Science, and Technology, Vol. 2, No 4, 2013, 760 –764 .
Lewis, W. K. (1921). The rate of drying of solid materials. J. of Industrial Eng., 5(13): 427-433.
Rustad,T.,(2003) Utilization of marine by-products, J. Environ. Agric. Food Chem., 2003, 2, 458. Fish silage produced with post-coagulation sludge 49.
Sobukola, O. P. and S. O. Olatunde (2011). Effect of salting techniques on salt uptake and drying kinetics of African catfish (Clarias gariepinus). Food and Bioproduct Processing, 89: 170-177.
Tayel,S.A.;T.H.Ghanem.;A.A.El-Messery and M.M.Badr,.(2012). Modelling A Microwave/Convection Dryer For Drying Of Potato Slices. Misr J. Ag. Eng., 29 (4): 1377 – 1398.
Togrul, I. T. and D. Pahlivan., (2002). Mathematical modeling of solar drying of apricots in thin layers. J. Food Eng. , 55, 209 : 216.
Zhiqiang, G.;X. Wang.,M. Li and X. Jiang,(2013). Mathematical Modeling on Hot Air Drying of Thin Layer Fresh Tilapia Fillets. Pol. J. Food Nutr. Sci., 2013, Vol. 63, No. 1, pp. 25-34. | ||
|
Statistics Article View: 172 PDF Download: 282 |
||
