ENGINEERING STUDY ON PLANTERS FURROW OPENER FOR ACCURATE PLANTING | ||
| Misr Journal of Agricultural Engineering | ||
| Article 4, Volume 30, Issue 4, October 2013, Pages 959-974 PDF (869.37 K) | ||
| Document Type: Original Article | ||
| DOI: 10.21608/mjae.2013.99568 | ||
| Authors | ||
| H. ELSHABRAWY1; R. M. SALIM2; W. M. Abdel-Salam3 | ||
| 1Prof. of Ag. Eng., Ag. Eng. dept., Fac. of Ag., Mansoura Univ., Egypt. | ||
| 2Sen. Res., Ag. Eng. Res. Inst., Ag. Res. Center, Dokki, Giza, Egypt. | ||
| 3Agricultural Engineer | ||
| Abstract | ||
| In order to increase agricultural production, the government had realized not only new techniques in agricultural field, but also modified and improved the capability of the available techniques. In fact, using planters and seed – drills in sowing process is considered one of the most important agricultural operations, to achieve the final aim from applied mechanization in sowing seeds.Soil collapsing phenomenon behind the furrow opener of planter, before deposit seeds, is considered one of the problems encountered in plants, because it does not only cause un regular seed depth, but also it strongly caused a bad effect on seed germination ratio and final yield. Therefore, the aims of this research are: (1) To study soil collapsing phenomenon behind the planters furrow opener, this causes high scale variety in sowing seed depth. (2) To determine the effect of irregular sowing seed depth on germination ratio and the lateral scattering of seeding plants. (3) To develop and design a new furrow opener for minimizing soil collapsing phenomenon behind the furrow opener of planters, and controlling the furrow depth for improving the contact area between seeds and soil particles. The tested factors were angle of ridge (A), A1(20º), A2(30º) , A3(40º) and A4(50º, ) Planting forward speed (F), (F1 ( 3 km/h), ( 3.5 km/h) and ( 4 km/h) and The depth of planting (d): , d1 (2 cm), d2 (3 cm), d3 (4 cm) and d4 (5 cm). The results showed that the highest germination ratio of plants (99.1%) was recorded at the lowest forward speed (3 km/h), and the highest depth of planting (d4 = 5 cm.) for furrow opener (50º angle of ridge), while the lowest germination plants ratio (92.7%) was gained at the highest planting speed of (4.5 km/h) and the lowest depth of planting (d1 = 2 cm.) for furrow opener (20º angle of ridge). | ||
| References | ||
|
Abd-Alla, H. EL. (1999), “Performance evaluation of a developed planter furrow opener”. Misr J. Ag. Eng., 16(2): 176 - 192.
Abo Habaga, M. M. (1990), “comparative studies on three chisel – plough share – forma.” Misr J. Ag. Eng. , 7(4) : 378 – 383.
Karayel , D. and Ozmerzi , A. (2006), "Comparison of vertical and lateral seed distribution of furrow openers using a new criterion". Soil and Tillage Research Volume 95, Issues 1-2, September 2007, pp. 69-75.
Karayel , D. (2009), "Performance of a modified precision vacuum seeder for no-till sowing of maize and soybean". Soil and Tillage Research Volume 104, Issue 1, June 2009, Pages 121-125.
Sanchez-Giron, V. , Ramı́rez , J. J. , Litago, J. J. and Hernanz, J.L. (2004), "Effect of soil compaction and water content on the resulting forces acting on three seed drill furrow openers". Soil and Tillage Research Volume 81, Issue 1, March 2005, 25-37.
| ||
|
Statistics Article View: 490 PDF Download: 658 |
||
